Thursday, September 4, 2014

Quality Stereo Wireless Microphone or Audio Link

Quality Stereo Wireless Microphone or Audio Link. This stereo FM wireless microphone also makes a great quality audio link. We tested it to beyond 50 meters and it was rock solid. It’s certainly not the first wireless microphone we’ve ever published but this one is a little different. It’s stereo, providing surprisingly good quality sound. Second, it has a really good range. We tested it at well over 50m and it was still performing very well – noise-free, in fact – but at the time we couldn’t get our receiver any further away. So it’s likely to have even better range than that.

main-quality-stereo-wireless-microphone-or-audio-link-schema

Complete Project:
quality-stereo-wireless-microphone-or-audio-link quality-stereo-wireless-microphone-or-audio-link-schema

Its easy to build, requires very little setup... and its cheap! In fact, the low price might turn some people off, thinking its low quality. Try it - and be pleasantly surprised!

quality-stereo-wireless-microphone-or-audio-link-front

Third, it really is simple to build – the hard work (the transmitter module) is already done for you. It’s just a matter of assembling the microphone module, which contains the electret mics themselves, preamp and level controls, and soldering the transmitter module onto it, "piggy back" style.

FM Transmitter:

Finally, the transmitter module is crystal-locked, so you won’t have the drift probles of some earlier wireless microphones. And just in case you were wondering, that doesn’t mean the output is locked to one particular frequency – it has a nifty synthesis schema built in to give you the choice of seven different frequencies between 106.7MHz and 107.7MHz.
On-board preset pots adjust the sensitivity of each channel to take into account mic differences or if you require different levels in each channel.

fm-transmitter-module-top-side-view

By the way, the transmitter module is quite capable of operating at line level if you want just a line level transmitter (eg, to feed an audio program around your home). Sensitivity is about 100mV. Oatley Electronics, who designed the kit, have the transmitter module available by itself if that’s what you’re after. But more on that anon.

fm-transmitter-module-bottom-side-view

Parts Layout:
parts-layout-quality-audio-link-schema-diagram
parts-layout-of-quality-stereo-wireless-microphone-or-audio-link

You also have the choice of two power supply levels – 3-6V or 7-15V DC. The latter results in a lower current drain. The transmitter module also has a "5V out" rail to supply power to the preamp module.

Quality Stereo Wireless Microphone Circuit Diagram:
quality-stereo-wireless-microphone-or-audio-link-schema-diagram

Two electret microphone inserts are supplied in the kit. These can be soldered direct to the PC board to make it a fully self-contained project or they can be attached to the board via suitable lengths of mini shielded coax cable. A third option is to use "proper" microphones – they can be electret or dynamic types – but no provision has been made for plugging these in.

Typical Specifications:
Audio response:.....................20Hz-15kHz.
Channel separation: ........................40dB
Total Harmonic Distortion: ...............0.1%
Output Frequency:...........106.7-107.2MHz
Pre Emphasis: ..................................50μS
DC supply voltage range: ................3-15V
Supply Current: .......................30mA @ 9V

0 comments:

Post a Comment

Note: Only a member of this blog may post a comment.