Monday, September 1, 2014

Simple FM transmitter with 2N3904

simple
In this section discuss about the series of mini fm transmitter, with broadcast coverage of about 300-400 meters. when using a 9 volt working voltage, the transmit power of about 300 meters and when using the working voltage 12 volts, the range of about 400-450 meters, depending on the antenna you use.

This scheme of simple fm transmitter
simple

For L1 and L2 windings 5 times the wrap, you can use a pen to fill melilitnya so neat and after lepaslah content of these pens. C5 is used for placement of broadcasting frequencies, can be tuned between 88-108 mhz, to reach further use steering antenna or Yagi antenna.

Part List
C1 = 0.001uF
C2 = 5.6pF
C3 = 10uF
C4 = 10uF
C5 = 3 - 18pF Adjustable capacitor
R1 = 270R
R2 = 4.7K
R3 = 10K
R4 = 100K
R5 = 4.7K
R6 = 4.7K
Q1 = 2N2222A
Q2 = 2N3904
L1 = 5 turn
L2 = 5 turn

Related Posts:

  • Simple 200W Audio AmplifierOutput Power : 200Watts Load Resistance : 8ohms Input impedance : 55K Maximum supply voltage : (+95v)-0-(-95v) Recommended supply voltage : (+66v)-0-(-66v) This complete high quality, low noise mono audio power amplifier is … Read More
  • Simple Source Voltage ProtectorProtection of electronic devices with a DC voltage source of voltage source obligatory reversal, especially protection of the source voltage is reversed. The definition of "Protectors Voltage Sources" in this article are the … Read More
  • Simple Bridge Rectifier Wiring diagram SchematicThis Simple Bridge Rectifier Circuit Diagram is intended for those cases where two unequal supply voltages are required. The lower voltage is obtained with the aid of a transformer with symmetric windings and half-wave rectif… Read More
  • Simple Power Switching Wiring diagram SchematicThis Simple Power Switching Circuit Diagram provides on/off switching, soft starting, current monitoring, current tripping, and protection against over-current for a 30 Vdc power supply at normal load currents up to 2 A. The … Read More
  • Simple MHz Oscillator using an ATtiny15Most engineers will recognise the problem: Your schema needs a stable 1 or 2 MHz clock generator (in the author’s case it was for a Pong game using an old AY3-8500). A suitable crystal is not to hand so you cobble together an… Read More

0 comments:

Post a Comment

Note: Only a member of this blog may post a comment.